Feature request: color dotP labels based-on value

Feature request: color dotP labels based-on value gabe  2020-04-06 12:09

We analyze datasets with many samples (typically 96) and rely critically on the dotP values displayed above each Peak-Area bar. Depending on the monitor and resolution, sometimes the dotP text is so small that it's very difficult to read. It would be helpful if these values could optionally be colored based on the value -- something like >0.9 green, between 0.7 and 0.9 orange, below 0.7 red. Ideally these would be user-configurable.


Brendan MacLean responded:  2022-12-26 16:31

This is an old one. We think we have done much better than this request by adding a mode where dotp/idotp/rdotp values are displayed as points on a line graph with the ability to set a cut-off value and points below the cut-off get highlighted in red. This allows a lot more information to be displayed in a range too narrow for text numbers to even be visible and legible.